Snow caster

A list of Frequently Asked Questions

Snow caster

Postby Ron Hopfensperger » Wed Feb 19, 2014 12:52 pm

Is there a special tool for pulling the auger bearing stub?

There is a bearing pressed into each end of the auger, inside each bearing a stub is pressed for the bolts to mount the auger into the housing of the snow caster. One of the bolts broke, I was hoping to remove the good stub and bearing then drive the broken one out with a piece of pipe, which I have done before, but that time one of the bearings was junk so it didn't matter if it came out in pieces.

Thanks
Ron
Last edited by Ron Hopfensperger on Wed Feb 19, 2014 1:24 pm, edited 1 time in total.
Ron Hopfensperger
 
Posts: 23
Joined: Tue Oct 26, 2010 7:28 am

Snow caster

Sponsor

Sponsor
 

Re: Snow caster

Postby batkerson » Wed Feb 19, 2014 1:04 pm

Not sure I understand the question.
My avatar is my wife's grandpa on his Case, which I now have.
http://www.case-ingersoll-tractors.com/ ... kerson.php
Brent Atkerson
http://www.quadaenterprises.com
User avatar
batkerson
Site Admin
 
Posts: 210
Joined: Wed Jul 07, 2010 6:26 pm
Location: Caro, MI


Return to FAQs

Who is online

Users browsing this forum: No registered users and 1 guest

cron